Arduino for STM32

SOLVED...

the library wasn't accessible from OSX.... had to install the homebrew system... now it works...

Well, I now have bought a STM-Link V2 connector... -> with STM-Link I can upload my sketches from Arduiono to the BluePill.... ok! -> with STM-Link and Boot Jumper 0 to HIGH I was able to upload the new generic stmduino bootloader.... ok! -> connected to USB Port and Boot Jumper 0 reset to LOW, the ...

Somehow I'm getting more and more confused... - can I use the onboard USB connector of the Blue Pill Board to programm from the ARDUINO IDE or do I always have to programm with a FTDI USB to Serial adapter? - do I have to modify the hardware on the Board with a pull up resistor? - what do I have to ...

Roger, the CH340 Chip is only on my Nano Board... currently I have no USB to Serial adapter... That means I have to manually program the bootloader into the board by connecting the STM32 board to a USB to serial adapter? Or can my nano board be coupled with the STM32 to program the bootloader? Thank...

Hi Chaps, after solving my first problems with CH340 driver for the Nano clones I got stuck by accessing the STM Blue Pill board under Mac OSX Sierra. I read some posts here in the forums but I didn't succeed yet... Hardware: STM32F103C8T6 USB Connection Cable Boot jumper 0 set to HIGH Boot jumper 1...

Hi Chaps,

I'm new to the Arduino world and was absent from electronics and programming almost 10 years now... I have mastered first steps with Arduino Nano boards and want to switch to more powerful STM hardware now. Since I am a Mac user the WILL be issues

Regards from Germany
Christian