STM8 - SDUINO - INTERRUPTS

[cfb95]

Hi,
i'm trying to use SDUINO on a cheap STM8S103F3 with external interrupts.
for example interrupt on pin 0 = PA1
Is possible to use attachInterrupt as Arduino does? parameters?
or i need to use StdPeriph api like this:

Code: Select all

  GPIO_Init(GPIOA,GPIO_PIN_1,GPIO_MODE_IN_FL_IT);
  EXTI_SetExtIntSensitivity(EXTI_PORT_GPIOA, EXTI_SENSITIVITY_RISE_ONLY);
  EXTI_SetTLISensitivity(EXTI_TLISENSITIVITY_RISE_ONLY);
  enableInterrupts();

or combination of both Arduino style + StdPeriph ?

Any example, doc, etc are welcome!
Thanks

[dannyf]

it cannot be that difficult to just set/clear a few bits to get exti work.

[ElDominio]

This would be nice for sure! This would be great now that EEPROM has been implemented